SENA ProBee-ZE10 - Manual (Page 85)

85 ProBee-ZE10 User Guide Rev.1.5
Response
<value><CR>
OK<CR>
OK<CR>
Default 100
Range 0 - 10000
9.2.2 S22
Description
Get/Set the timeout to permit joining. It determines the time in seconds that the device
will allow other devices to join to it when it starts network but an end-device cannot
perform it. If set to 255, the device will always permit joining.
Execute ATS22?<CR> ATS22=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 255
Range 0 - 255
9.2.3 S23
Description
Get/Set the power boost mode of the module. If enabled, boost mode improves
sensitivity by 1dB and increases output power by 2dB, improving the link margin and
range.
Execute ATS23?<CR> ATS23=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 1
9.3 Data Transmissions
9.3.1 S31
Description
Get/Set the application-ACK mode. If it is enabled, a sender node retransmits data
packet when it fails to receive ACK from receiver node. This value must be set same
on the source and destination node for data transmission.
Execute ATS31?<CR> ATS31=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range 0 - 1
9.3.2 S32
Description
Get/Set the transmission retries. A sender tries to retransmit up to this value when
transmission fails. (CAUTION: It is recommended to set the smallest value that the