Installation, Network settings – SENA Parani-MSP100 User Manual
Page 10
10
3. Installation
3.1. Network Settings
(1) Parani-MSP100 power-up; ‘POWER’and ‘STATUS’LEDs display green
(2) Parani-MSP100 network configuration: connect Parani-MSP100 to PC via RS232
cable(Position of DIP switch is on the side of drawing
.)
(3) Open HyperTerminal
(4) Set PC COM port;
Baud rate 115200 / 8 Data bit / non-parity / 1 stop bit / no hardware flow control
(5) Press Enter key; the following information as is displayed on a HyperTerminal
screen; If Parani -MSP100 prompts Login ID / password, default values are:
Login: admin
Password: admin
RS232 Mode
Parani -MSP100
Installation
Network Configuration
Serial Port Configuration
Change of DIPswitch
Configuration via serial cable
Mode configuration
Connection from Bluetooth Terminal device
(Parani-SD)
TCP/IP mode