SENA Parani-MSP100 - Manual (Page 43)

43
stalled unintentionally, Parani-MSP100 cannot aware this unexpected
disconnection. Accordingly, Parani-MSP100 sends beacon packets to
monitor connection status when there is no data communication for certain
time.
When there is no data communication for <time>, Parani-MSP100 will
send beacon packet <probe> times to monitor the connection, by each
<interval>, before closing the connection. Below example means when
there is no communication for 10 min., Parani-MSP100 will send beacon
packets 3 times by 10 seconds interval.
Ex.: KATO 600 3 10
+OK KATO 600 3 10
A.3. Commands for Client Mode
SERV <IP Address:Port> [bdaddr|name]
: To assign IP address and port number of server host where Parani-
MSP100 will send connection request in client mode. If you enter either
bluetooth address or friendly name of the Bluetooth device, you may
configure different host addresses and port numbers for each Bluetooth
devices.
Response: index|name|bdaddr|server_IP:port
Ex.: SERV 192.168.1.11:9000
+OK
SERV 192.168.1.11:9001 Parani-SD
+OK
SERV
0|Parani-SD||192.168.1.11:9001
+OK 192.168.1.11:9000
DELSERV <bdaddr|name>
: To delete Host information stored by SERV command.
Ex.: DELSERV Parani-SD
+OK
REPT <interval>
: When connection to Host is failed, users may configure Retrial period of
connection. Unit: millisecond, Default value: 5000 ms
If the value is ‘0’, Parani-MSP100 will try to recover connection only once.