SENA Parani-MSP100 - Manual (Page 16)

16
3.3.2 Firmware Upgrade via Xmodem
Users may upgrade the firmware using Xmodem protocol via RS232 serial cable.
<Upgrade firmware via Xmodem>
3.4 Serial Port
Serial port of Parani-MSP100 can be used for both Configuration and Data communication. For
configuration, users need to change the DIPswitch of Parani-MSP100 to the right.
Users may set configuration of serial port communication in this menu.
Below figure is showing that ‘115200 bps 8-N-1 hardware’which means ‘115200 bps, 8 data bit, None
parity, 1 stop bit, hardware flow control (RTS/CTS).