SENA Parani-MSP100 - Manual (Page 47)

47
: Displays current Bluetooth device status
If any background task running, it will show [PENDING].
Response: idx|bdaddr|tx_byte|rx_byte|err_tx|err_rx
Ex.: STAT
0|00:0B:53:20:00:63|1710|3513|0|0
+OK
AFH [channel] …
: This command will activate 802.11b Wi-Fi Combo mode, in which Parani-
MSP100 doesn’t make use of the ranges of frequencies where co-existing
802.11b Wi -Fi devices work.
Specify channel 0(zero) to disable combo mode.
When enabled, overall throughput will be reduced.
Ex.: AFH 10 11
+OK
AFH
+OK AFH 10 11
AFH 0
+OK
A.8. Commands for Bluetooth Connection Management
LIST
: To see connected Bluetooth device list.
Higher link quality, better link status. Zero rssi means the most efficient RF
condition (so called ‘Golden Range’).
With link quality lower than 200, throughput may be affected or link may be
lost.
Response: idx|dev_id|port|bdaddr|name|tx_byte|rx_byte|link_quality|rssi
Ex.: LIST
0|0|5000|00:0B:53:00:00:8A|SDv3b-00008A|0|0|255|0
+OK
CONN <bdaddr> [channel]
: Parani-MSP100 may try to CONNECT to Bluetooth devices. If you specify
a channel, Parani-MSP100 will try connection directly skipping SDP
(Service Discovery Protocol) process.
Each device to connect should be in connectable mode.
Ex.: CONN 00:0B:53:00:00:8A
+OK