SENA Parani-MSP100 - Manual (Page 52)

52
Appendix B: AT Commands
Parani-MSP100 supports user friendly AT commands. Make sure this feature enabled in configuration
console in order to use AT commands.
Most of them are compatible with Parani-SD but some have differences in their usage and some
commands are appended for Parani-MSP100 exclusive use.
Supported AT commands and their differences from AT command of Parani-SD are summarized as
below. Please refer to Parani-SD userguide for more information.
Command Description Example
AT Check if the connection to host equipment is
operating normally. The serial parameters of
Parani-MSP100 must be same as those of
host equipment. If not, the MSP will not
respond or ‘ERROR’ message will appear or
an abnormal sequence of strings will appear.
ATZ This has the same effects as Powercycling the
unit. This command disconnects any
connected Bluetooth device, and stops