SENA Parani-MSP100 - Manual (Page 44)

44
Ex.: REPT 3000
+OK REPEAT every 3000 ms
PSIST <on|off>
: In Client mode, in the event of TCP disconnection, Parani-MSP100 ™
automatically attempts to recover TCP connection when PSIST is set to
ON, in the period of pre-defined ms by REPT command.
Ex.: PSIST ON
+OK PERSIST on
A.4. Commands for Vertex Mode
VERTEX <port no.> [number of clients]
: To assign port number where Parani-MSP100 waits for connection in
Vertex mode.
Parani-MSP100 ™ Vertex Mode avails Wireless RS485 multi-drop service
when assigned at this site.
Ex.: VERTEX 4000 1
+OK PORT 4000 MAX 1
A.5. Commands for Serial Hub Mode
ROUTE <add> <src> <dst>
<del> <src> <dst>
<ptp|multi|manual>
: To configure Routing table for Repeater Mode.
src: Bluetooth address of source device
dst: Bluetooth address of destination device
Response: src > dst
Ex.: ROUTE
00:0B:53:12:03:A8 > 00:00:00:00:00:00
00:00:00:00:00:00 > 00:0B:53:12:03:A8
+OK
A.6. Commands for Repeater Mode
STATION <bdaddr>
: To configure Bluetooth address of station Parani-MSP100.
In repeater mode Parani-MSP100 will try to connect to this device.