SENA ProBee-ZE20S-SEME - Manual (Page 60)

ProBee-ZE20S-SExx User Guide Rev 1.8 60
# KEY(Link Key) is changed by initiate Key Establishment
2/6 ENTRIES USED
OK
Key Table of ProBeeSEID is also changed as follows:
#Screen of ProBeeSEID(end-device)
AT+KEYTABLE
NETWORK KEY: FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
LINK KEY TABLE
#|IEEE_ADDRESS |TYPE|AUTH|KEY
*|000195AABBCC0000|LINK|YES |C9AF9B248454840FDD80AAFBBAA4028F
1/6 ENTRIES USED
# Trust Center Link Key(Number *) is changed
# AUTH(Authentication) is changed NO to YES
# KEY(Link Key) is changed by initiate Key Establishment
1/6 ENTRIES USED
OK
Example) Initiate Key Establishment from ProBeeSESI(coordinator) to ProBeeSEME(end-device)
#Screen of ProBeeSESI(coordinator)
AT+DEST=000195AABBCC0002,01 # Set destination node to ProBeeSEME(0xAB74),
# End-point is 0x01
DESTINATION ADDRESS: 0xAB74, END POINT: 0x01
OK
AT+CBKESTART
CBKE DEST: 0xAB74, EP: 0x01, RESULT: 0x00
OK
+AB74|SE_INIT_CBKE_RESPONSE # +AB74 is short address of end-device,
+AB74|SE_EPHEMERAL_DATA_RESPONSE # it can be shown differently
+AB74|SE_CONFIRM_KEY_DATA_RESPONSE # in your screen
Then ProBeeSEME(end-device) node receives following messages:
#Screen of ProBeeSEME(end-device)
+0000|SE_INIT_CBKE_REQUEST