SENA ProBee-ZE20S-SEME - Manual (Page 80)

ProBee-ZE20S-SExx User Guide Rev 1.8 80
Response
List of the S-register
and description
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
7.2.5 ATZ
Description Reset the node.
Execute ATZ<CR>
Response OK<CR>
7.2.6 AT&F
Description Factory reset.
Execute AT&F<CR>
Response OK<CR>
7.2.7 ATU
Description
Get/Set UTC time format type for input/output.
(0: 32-bit hexadecimal ranging 0x00000000 ~ 0xFFFFFFFF,
1: MM-DD-YYYY/hh:mm:ss,
2: DD-MM-YYYY/hh:mm:ss,
3: YYYY-MM-DD/hh:mm:ss).
Execute ATU?<CR> ATU=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 1
Range 0 - 3
7.3 Node Specific Information
7.3.1 AT+LONGADDR or AT+LA
Description
Get the 64-bit IEEE address. (EUI address, long address) The IEEE address is a
unique device address assigned during manufacturing. This address is unique to
each physical device.
Execute AT+LONGADDR?<CR>
Response
<IEEE address><CR>
OK<CR>
7.3.2 AT+SHORTADDR or AT+SA
Description
Get the 16-bit Node ID. (network address, short address) The node ID of “0000”
is reserved for the coordinator. All other devices receive a randomly generated
address from the coordinator or router device that allows the join. This value can
change if an address conflict is detected where two devices are found to have the