SENA ProBee-ZE20S-SEME User Manual
Page 87
ProBee-ZE20S-SExx User Guide Rev 1.8
87
7.8.2
AT+NWKKEY or AT+NK
Description
Get/Set the 128-bit network key. (0 or 0s: generate random 128-bit number)
Execute
AT+NWKKEY?<CR>
AT+NWKKEY=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
7.8.3
AT+UPDATEKEY or AT+UK
Description
Update the network key with a new generated key. (possible only for coordinator)
It is applied after 30s later because sending too quickly may cause a sleepy end-
device to miss the alternate encryption key and only get the switch key message,
which means it will be unable to change to the new network key.
Execute
AT+UPDATEKEY<CR>
Response
OK<CR> or ERROR<CR>
7.8.4
AT+KEYTABLE or AT+KT
Description
Get/Set/Remove link key table.
Execute
AT+KEYTABLE?<C
R>
AT+KEYTABLE=<num>,
<IEEE
address>,<link
key><CR>
AT+KEYTABLE=<num><CR>
Response
<list of the link key
table>
OK<CR>
or
ERROR<CR>
KEY
TABLE
<num>
REMOVED<CR>
OK<CR> or ERROR<CR>
7.9
UART
7.9.1
AT+BAUDRATE or AT+UB
Description
Get/Set the serial port speed for communication between the module serial port
and host.
Execute
AT+BAUDRATE?<CR>
AT+BAUDRATE=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default
9600
Range
300 – 230400
7.9.2
AT+DATABIT or AT+UD
Description
Get/Set the serial data bit setting on the module.
Execute
AT+DATABIT?<CR>
AT+DATABIT=<value><CR>