SENA ProBee-ZE20S-SEME - Manual (Page 99)

ProBee-ZE20S-SExx User Guide Rev 1.8 99
Response
<UTC time><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 01-01-2000/00:00:00
Range 01-01-2000/00:00:00 - 02-07-2136/06:28:15
7.14.9 AT+MSGETLAST or AT+MGL
Description
Send ‘Get Last Message’ command(Messaging cluster) to destination node.
(client-side command)
Execute
AT+DEST=<address>,<endpoint><CR>
AT+MSGETLAST<CR>
Response OK<CR> or ERROR<CR>
7.14.10 AT+DLLIST or AT+DLT
Description Show DRLC Event List.
Execute AT+DLLIST?<CR>
Response
event ID|clss|gr|dura|cr|cool(sp)|heat(sp)|av|du|ct|start time
..
OK<CR>
7.14.11 AT+DLSTARTTIME or AT+DST
Description
Get/Set DRLC Start Time. This value will be used in AT+DLUPDATE and
AT+DLGETSCH. The format of time is determined by ATU value.
Execute AT+DLSTARTTIME?<CR> AT+DLSTARTTIME=<UTC time>
Response
<UTC time><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 01-01-2000/00:00:00
Range 01-01-2000/00:00:00 - 02-07-2136/06:28:15
7.14.12 AT+DLUPDATE or AT+DLU
Description Update DRLC Event.
Execute
AT+DLUPDATE=<event ID>,<criticality level>,<cooling set point>,<heating set
point>,<average load adjustment percentage>,<duty cycle>,<event
control><CR>
Response OK<CR> or ERROR<CR>
7.14.13 AT+DLREPORTES or AT+DRE
Description
Send ‘Report Event Status’ command(DRLC cluster) to destination node. (client-
side command)
Execute AT+DEST=<address>,<endpoint><CR>