SENA ProBee-ZE20S-SEME User Manual
Page 86
ProBee-ZE20S-SExx User Guide Rev 1.8
86
Response
OK<CR>
7.6.2
AT+PARENTLA or AT+PL
Description
Get the 64-bit IEEE address of the parent node.
Execute
AT+PARENTLA?<CR>
Response
<IEEE address><CR>
OK<CR>
7.6.3
AT+PARENTSA or AT+PS
Description
Get the 16-bit Node ID of the parent node.
Execute
AT+PARENTSA?<CR>
Response
<node ID><CR>
OK<CR>
7.6.4
AT+CHILDTABLE or AT+CT
Description
Get the child table composed of the end-devices.
Execute
AT+CHILDTABLE?<CR>
Response
<node type>|<IEEE address>|<node ID>
List of the child nodes…
OK<CR>
7.7
Data Transmission and Reception
7.7.1
AT+MAXPAYLOAD or AT+MP
Description
Get the maximum size of the payload that the Application Support sub-layer will
accept. The size depends on the security level in use.
Execute
AT+MAXPAYLOAD?<CR>
Response
<value><CR>
OK<CR>
7.8
Security
7.8.1
AT+SECURITY or AT+SE
Description
Get/Set the security status. (0: turning security off, 1: on) Every node must be
under the same security level in the network. Do NOT change default value if you
want to use for Smart Energy node.
Execute
AT+SECURITY?<CR>
AT+SECURITY=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default
1
Range
0 – 1