SENA ProBee-ZE20S-SEME - Manual (Page 81)

ProBee-ZE20S-SExx User Guide Rev 1.8 81
same address or a device leaves the network and later joins.
Execute AT+SHORTADDR?<CR>
Response
<node ID><CR>
OK<CR>
7.3.3 AT+ADDRDISCOVERY or AT+AD
Description Get the corresponding address of a node whose long or short address is known.
Execute AT+ADDRDISCOVERY=<IEEE><CR> AT+ADDRDISCOVERY=<nodeID><CR>
Response
<node ID><CR>
OK<CR>
<IEEE address><CR>
OK<CR>
7.3.4 AT+OPCH or AT+OC
Description
Get the operating channel number used for transmitting and receiving between
RF modules. Uses 802.15.4 channel numbers. A value of “0” means the device
has not joined a PAN and is not operating on any channel.
Execute AT+OPCH?<CR>
Response
<value><CR>
OK<CR>
7.3.5 AT+OPPANID or AT+OI
Description
Get the operating 16-bit PAN ID. If PAN ID is set specific value not 0s, operating
PAN ID will equal designated PAN ID. A value of “FFFF” means the device is not
joined a network.
Execute AT+OPPANID?<CR>
Response
<value><CR>
OK<CR>
7.3.6 AT+OPEPID or AT+OE
Description
Get the operating 64-bit extended PAN ID. A value of “FFFFFFFFFFFFFFFF”
means the device is not joined a network.
Execute AT+OPEPID?<CR>
Response
<value><CR>
OK<CR>
7.3.7 AT+VERSION or AT+VR
Description
Get firmware version of the module. The firmware version returns a form of
“SExxvx.x”.
Execute AT+VERSION?<CR>
Response <value><CR>