GE Industrial Solutions 6KCV300WPD - Manual (Page 22)

4.4.3 Selection Bar
The block selection bar provides quick access to the building blocks of the schematics. It is divided into two
parts: the left part is used for selecting a group. The members of the selected group are displayed on the right
half of the bar. Placing of a block is done by dragging and dropping a block into the schematic.
The block selection bar can be made hidden or visible by the menu item Block of the View menu.
Figure 4.4.3.1: Block Selection Bar
4.4.4 Status Bar
,
Figure 4.4.4.1: Status Bar
,
The status bar is located at the bottom of the main window and gives information about the schematic being
edited On the left side the following items are displayed:
if the mouse pointer is on a button of the an explanation of the button is given
if the mouse pointer is on a button of the block selection bar, its name is displayed
if the mouse is within the schematic during editing the name of the block it is pointing to is displayed
in all other cases this part is left empty
The right part of the status bar displays information about the status of the project:
saved saving disk,
changed after editing changes,
if simulation is active.
1 2