GE Industrial Solutions 6KCV300WPD - Manual (Page 70)

GEL100340
l
Description
The block estimates winder diameter (Diameter) and material thickness (Thick) from
measured line speed and winder motor speed using a algorithm with two time
constants: and
It is used to estimate rewinder or unwinder diameter with or without dancer.
is gear-box ratio of winder.
is a input that controls units of line speed, winder motor speed, diameter and thickness. The follow-
ing table explains all available units system:
speed Winder motor speed Diameter
0 European units mm
1 USA units inches
otherwise International System meters meters
of units
Control input can enable or disable the functionalities of diamobs block according to the following table:
6 0