GE Industrial Solutions 6KCV300WPD - Manual (Page 35)

5.8 Printing Schematics
For documentation purposes schematics can be printed. Printing is started by the Print command
from the File menu. A dialog appears that is used for setting the print options. There are two modes for
printing schematics:
window print mode
page print mode
The window print mode is used for draft printouts, while the page print mode delivers document ready prints.
Both modes are started from the Print item of the File menu.
Figure 5.8.1: Window Print Mode Dialog
Printing in Window Mode
For printing a scheme in window mode select Print from the File menu and then Window mode from the tab
riders of the dialog. The window mode dialog appears.
Within this dialog you can change the following options:
the margins of the printing at all four borders in inches. These margins will not be printed. They should be
bigger than the printer margins.
the print range can be selected between the visible window and the whole schematic.
the printing especially for larger schematics can be divided onto more than one page. For this purpose the
Multipage
has to be marked.
If the Keep aspect ratio is checked, the magnification in x- and y-direction is the same. Otherwise they are
optimized to fit the schematic to the page.
If the Frame around page is checked, a border and a headline will be printed to identify the printout.
OK starts the printing while Cancel aborts it. Setup can be used to open the Page Setup dialog.
2 5