Proface LT4300M - 5.7 Modular HMI + Control" - Manual (Page 61)

LT-4201TM/4301TM Hardware Manual
61
Panel Cut-Out Dimensions and Installation
Inserting a Display Module Without an Anti-Rotation Tee
Create a panel cut-out and insert the display module into the panel from the front.
The figure shows the panel cut-out:
Dimensions
NOTE: Without the tee option, the display module supports a rotating torque of 2.5 N•m (22.12 lb-
in).
Inserting a Display Module With an Anti-Rotation Tee
Create a panel cut-out and insert the display module into the panel from the front.
The figure shows the panel cut-out for a LT Unit using a tee:
A B (1) B (2)
22.50 0/-0.30 mm
(0.88 0/-0.01 in.)
1.5...6 mm
(0.06...0.23 in.) 3...6 mm
(0.11...0.23 in.)
(1) Steel sheet
(2) Glass fiber reinforced plastics (minimum GF30)