Proface LT4300M - 5.7 Modular HMI + Control" - Manual (Page 86)

LT Installation
86
USB (mini-B)
Introduction
When using a USB device, you can attach a USB holder to the USB interface on the unit to help
prevent the USB cable from being disconnected.
NOTE: The USB holder is supplied in the accessory kit PFXZGMAK1 (sold separately).
Attaching the USB Holder
WARNING
RISK OF EXPLOSION IN HAZARDOUS LOCATIONS
In hazardous locations as described in ANSI/ISA - 12.12.01:
 Confirm that the USB cable has been attached with the USB cable clamp before using the USB
host interface.
 Remove power before attaching or detaching any connector(s) to or from the unit.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
Step Action
1 Insert the USB cable into the USB host interface.
1 USB cable