Proface LT4300M - 5.7 Modular HMI + Control" - Manual (Page 79)

LT-4201TM/4301TM Hardware Manual
79
NOTE:
 Do not solder the wire directly to the power receptacle pin.
 The power supply cord must meet the specification shown above. Twist the power cords
together, up to the power plug, for EMC compliance.
 Use field wiring terminal marking for wire type (75 ° C (167 ° F) copper conductors only).
5 Push the Opening button with a small and flat screwdriver to open the desired
pin hole.
6 Insert each pin terminal into its corresponding hole. Release the Opening
button to clamp the pin in place.
7 After inserting all three pins, insert the power plug into the power connector on
the LT.
Step Action