Actron CP9190 - Manual (Page 153)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 6 – 31
Ford Enhanced (OBD II) Diagnostics
6
– Tool Setup Menu
– English/Metric
– Contrast Adjust
– Beeper
– Setup User Key
If the function is not supported by the vehicle, the Scan Tool
does not display it.
✓
If an Error Message displays, make sure the OBD II connector
is securely attached, and the ignition key is on. Cycle the ignition
key to off for 10 seconds, then on. This may be required to reset
the computer. If required, select yes to try again. If the problem still
exists, refer to Error Messages on page 9-2.
Diagnostic Codes Menu
All items marked with “-” are covered either in section 3 or
4. These items are not covered in this section.
❒
Diagnostic Codes Menu
❒
Read Codes
– Pending Codes
– Erase Codes
– View Freeze Data
– Review Data
– Print Data
– Code Lookup
– Tool Setup
Read Codes
✓
The Read Codes function retrieves DTCs from the vehicle’s
computer module(s). This function can be performed KOEO or
KOER. The Read Codes function retrieves all DTCs (MIL,
non-MIL and Pending) stored in the vehicle’s computer module(s).
IMPORTANT
IMPORTANT