Actron CP9190 - Manual (Page 98)

Global OBD II Diagnostics
4 – 34 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4 4
✓
The manufacturer is responsible for determining the criteria to
automatically stop test. Refer to appropriate vehicle service manual.
Vehicle Info
The Vehicle Info function allows the Scan Tool to request the vehicle’s
VIN number, calibration ID(s) which identifies software version in
vehicle control module(s), calibration verification numbers (CVN(s))
and in-use performance tracking.
✓
Vehicle Info function applies to model year 2000 and newer OBD II
compliant vehicles.
✓
The Scan Tool cannot verify if data is correct for scanned vehicles.
✓
CVNs are calculated values required by OBD II regulations.
✓
The CVN calculation may take several minutes.
✓
CVNs are reported to determine if emission-related calibrations have
been changed. Multiple CVNs may be reported for a control module.
✓
In-use performance tracking, tracks performance of key readiness
Monitors.
From the Special Tests Menu:
1. Select Vehicle Info.
•Use
UP or DOWN arrow
key until Vehicle Info is
highlighted.
•Press
ENTER.
I/M Readiness ?
Drive Cycle Monitor
State OBD Check
O2 Monitor Test
Diag Mon Tests
On-Board Systems
Vehicle Info
Special Tests Menu
Vehicle Info