Actron CP9190 - Manual (Page 51)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 17
Using The Scan Tool
3
Program Mode
The Program Mode is used for
reprogramming the Scan Tool with
English, Spanish or French
languages. The Scan Tool is
programmed with English by
default.
The Program Mode is also used for
updating the Scan Tool. Instructions
are provided with upgrades.
Connecting The Scan Tool
To diagnose a vehicle, connect the DLC and power adapter (if
applicable) to the Scan Tool. Refer to “Data Link Connector (DLC)” on
page 2-9 of Getting Started.
If you just want to power up the tool to do self-tests, code lookup, review
or printing data from the last vehicle tested, then you do not need to
attach the cable to the DLC. The internal battery provides power for this
.
1.Connect appropriate cable to Scan
Tool
•Make sure pins are not bent.
✓
Depending on vehicle, either the OBD II
Cable or Extension Cable is required.
Beeper
Auto Power Off
Tool Information
Display Test
Keyboard Test
Memory Test
Program Mode
System Setup
Program Mode