HT instruments MACROTEST G3 - Manual (Page 81)

MACROTESTG3 - COMBIG3
EN - 80
8. CONNECTING THE INSTRUMENT TO A PC
The connection between a PC and the instrument can be done via a serial port (see Fig. 3)
by means of an optical cable/USB C2006 or by means of an optical/wiFi adapter (optional
accessory C2013). Before making the connection in USB mode, it is necessary to install
on the PC the C2006 cable drivers present in the supplied CD-ROM in addition to the
management software. To transfer stored data to PC keep to the following procedure:
Connection to PC via optical/USB cable
1. Switch on the instrument by pressing the ON/OFF key.
2. Connect the instrument to the PC via the optical cable/USB.
3.
Touch the icon in the general menu. The screen
to the side is shown by the instrument.
In these conditions, the instrument is able to
communicate with the PC.
4. Use the management software to download the instrument memory contents to a PC.
Please refer to the online help of the program itself for any detail regarding the
operation.
5.
Touch the icon to go back to the general menu of the instrument.
Connecting to a PC through WiFi
1. Enable the WiFi connection on the target PC (ex: by using a WiFi key installed and
connected to a USB port).
2. Switch on the optional accessory C2013. The ON LED flashes. Wait for the C2013
recognition by the PC and perform the connection
3. Insert the C2013 into the instrument via the serial optical port (see Fig. 3).
4. Put the instrument in data transfer mode to a PC (see § 8 - point 3).
5. Launch the management software, select the "WiFi" port and "Detect instrument" within
the section "PC-Instrument connection". Once the instrument recognized, the "WiFi"
LED on the C2013 flashes together with the "ON" LED.
6. Use the management software to download the instrument memory contents to a PC.
Please refer to the online help of the program itself for any detail regarding the
operation.
8.1. CONNECTION TO IOS/ANDROID DEVICES THROUGH WIFI
The instrument can be connected remotely via WiFi connection to a Android/iOS
smartphones and/or tablets for the transfer of measurement data using the optional
accessory C2013 (see the accessory user guide) and the APP HTAnalysis. Proceed as
follows:
1. Download and install the HTAnalysis on the desired remote device (Android/iOS).
2. Switch on the optional accessory C2013. The ON LED flashes. Wait for the C2013
recognition by the remote device
3. Insert the C2013 into the instrument via the serial optical port (see Fig. 3).
4. Put the instrument in data transfer mode to a PC (see § 8 - point 3).
5. Take reference to the HTAnalysis instruction for the management operation