HT instruments MACROTEST G3 - Manual (Page 23)

MACROTESTG3 - COMBIG3
EN - 22
1.
Touch the icon. The screen to the side appears
on the display.
Touch the icon to the left to set the RCD operating
mode. The following screen appears on the display:
2. Move the slide bar reference by selecting the
desired operating mode between the options: G
(General), S (Selective), (Delayed).
Confirm the choice by going back to the initial
measurement screen. Note the presence of the
chosen selection.
When selecting a Delayed RCD, the instrument
displays the following screen.
3.
Touch the icon to zero the value in the Timer
field and use the virtual keyboard to set the value
of RCD delay time in seconds between 1ms and
500ms. Confirm the choice by going back to the
initial measurement screen.
Touch the second icon to set the type of RCD, the
waveform and the tripping current. The following
screen appears on the display.
4. Move the left slide bar reference and select the
type of RCD between the following options: STD
(molded case RCD) and “
” (earth leakage
delay RCD with use of optional accessory
RCDX10). In case of earth leakage relay RCD the
following screen appears on the display