Jenway 6715 - Manual (Page 144)

126
SeCtion 10 - Fitting Alternative Modules/Accessories
10.1 inteGrAl Printer Unit
Disconnect the instrument from the mains supply.
The printer lid is located on the upper left hand side of the instrument casing. Release the lid or
printer by inserting a thin blade into the retaining tab access and then pressing both the tabs inwards.
Carefully remove the lid and retain for possible future requirements.
The printer connection lead is attached to the inside of the lid. Care should be taken when removing
the lid from the instrument to ensure no damage occurs.
Remove the printer module from the packaging and insert into the recess taking care to secure into
the retaining tabs. Detach the printer connection lead from the top of the lid and carefully fit to
the printer module. Reconnect the instrument to the mains supply via the rear panel socket. The
instrument and printer are now ready for use.
Printer roll replacement
Printer unit
Printer lid
Lid and printer
retaining tab
access