Jenway 6715 User Manual
Page 147
129
Unpack the new module and check to ensure no damage has occurred during transit. To install the
new module raise the lid by 30° and gently ease it into the instrument compartment taking care that
the lugs shown in the diagram locate into the main casework. Once the module is in position, tighten
the sample chamber retaining screw.
installation - 8 Cell Changer Carousel
If your instrument was ordered with the automatic 8 cell changer it will be supplied with the module
installed but with the carousel packed separately to avoid damage in transit. This should be un-packed
and be carefully located onto the motor shaft by gently pushing it down onto the shaft.
The carousel should then be rotated until the carousel drive is engaged. No additional alignment is
required.