Jenway 6715 - Manual (Page 152)

134
This is supplied as a complete plug-in module as detailed above. If you are changing from an existing
sample chamber module to the sipper pump the following installation instructions should be used:
Disconnect the instrument from the mains supply.
Check the installed sample chamber module and remove any filled cuvettes to avoid spillage.
Raise the lid and loosen the sample chamber retaining screw located at the front of the module. Lifting
the front carefully remove the module from the instrument and store safely for possible future use.
Unpack the new module and check to ensure no damage has occurred during transit.
To install the new module raise the lid by 30° and gently ease it into the instrument compartment
taking care that the lugs shown in the diagram locate into the main casework.
Once the module is in position, tighten the sample chamber retaining screw.
Re-connect the mains supply to the rear panel of the instrument. Switch the instrument on using the
power switch located on the rear panel. The instrument is now ready for use with the new module.
The instrument will then perform the power on self-test protocol. The power on and self-test screen
will be shown:
If the module has been successfully installed the instrument will show ‘Sipper’ alongside the
Accessory test… indicator.
If the module is incorrectly fitted to the instrument the message ‘none Found’ will be displayed. If
this occurs switch the instrument off and disconnect from the mains supply. Remove the module and
carefully refit. Reconnect the instrument to the mains supply and switch on. If the fault remains please
contact your local dealer for advice.
Fitting the Sipper Pump tubing
The Tubing Kit supplied with this module contains:
• Sipper Pump Tubing (1 metre) – 023 029
• Capillary Tubing (0.5 metre) – 023 030
• Sipper Probe – 632 063
In addition a 2.5mm Sample Mask (035 242) for use with micro cell, is supplied with the accessory
module.