Jenway 6715 - Manual (Page 148)

130
installation – 6 Cell Changer Carousel
If your instrument was ordered with the automatic 6 cell changer it will be supplied with the module
installed but with the carousel packed separately to avoid damage in transit. This should be un-packed
and be carefully located onto the motor shaft. Line up the 2 orientation marks (1) and fully tighten the
thumbscrew (2). No additional alignment is required.
tubing
note: The 6 cell changer is supplied with 2 metres of silicon tubing (023 027). The use of alternative
tubing or using lengths in excess of 1 metre is not recommended.
Feed the tubing through the front of the module (3), leaving sufficient slack in the tubing to allow free
rotation of the turret, and without causing pinching or excessive straining on the tubes. Pass through
the guide (4) and push firmly over the connector (5). Fit both tubes in the same manner.
Re-connect the mains supply to the rear panel of the instrument. The instrument is now ready for use
with the new module.
The instrument will then perform the power on self-test protocol. The power on and self-test screen
will be shown:
4
5
3
1 2