Chap. 10 specification, 1 safety requirements, 2 general specification – KYORITSU 6315 Instruction Manual User Manual

Page 132

Advertising
background image

KEW6315

10.1 Safety requirements

KEW6315

- 130 -

Chap. 10 Specification

10.1 Safety requirements

Location for use

: In door use, Altitude up to 2000m

Temperature & humidity range : 23ºC±5ºC, Relative humidity 85% or less (no condensation)

(guaranteed accuracy)

Operating Temperature &

: 0ºC to 45ºC, Relative humidity 85% or less (no condensation)

humidity range

Storage Temperature &

: -20ºC to 60ºC, Relative humidity 85% or less (no condensation)

humidity range

Withstand voltage

AC5160V/ for 5 sec.

Between (AC Voltage input terminal) and (Enclosure)

AC3310V/ for 5 sec.

Between (AC Voltage input terminal) and (Current input terminal, Power connector,

USB connector)

AC2210V/ for 5 sec.

Between (Power connector) and (Current input terminal, USB connector,

Enclosure)

Insulation resistance

: 50MΩ or more / 1000V; Between (Voltage/Current input terminal,

Power connector) and (Enclosure)

Applicable standards

: IEC 61010-1 Measurement CAT.IV 300V CAT.III 600V CAT.II 1000V

Pollution degree 2, IEC 61010-031, IEC61326 Class A

Dust-/ water-proof

: IEC 60529 IP40

10.2 General specification

Measured line and Input ch

: Current ch (A2-A4) unrelated to the selected wiring system can be

used for any measurement purpose.

Wiring system

Input ch

Voltage

Current

Single-phase2-wire-1-system (1P2W-1)

VN-V1

A1

Single-phase2-wire-2-system (1P2W-2)

VN-V1

A1,A2

Single-phase2-wire-3-system (1P2W-3)

VN-V1

A1,A2,A3

Single-phase2-wire-4-system (1P2W-4)

VN-V1

A1,A2,A3,A4

Single-phase3-wire-1-system (1P3W-1)

VN-V1,V2

A1,A2

Single-phase3-wire-2-system (1P3W-2)

VN-V1,V2

A1,A2,A3,A4

Three-phase3-wire-1-system (3P3W-1)

VN-V1,V2

A1,A2

Three-phase3-wire-2-system (3P3W-2)

VN-V1,V2

A1,A2,A3,A4

Three-phase3-wire(3P3W3A)

V1-V2,V2-V3,V3-V1

A1,A2,A3

Three-phase4-wire(3P4W)

VN-V1,V2,V3

A1,A2,A3

LCD

: 3.5inch, TFT, QVGA(320×RGB×240)

Display update

: every 1 sec*

* There may be time lag in display update (max. 2 sec) due to arithmetic processing,

however, no time lag between the recorded data and the time stamp.

Advertising