KYORITSU 6315 Instruction Manual - Manual (Page 48)

KEW6315
KEW6315 - 46
Switching of displayed parameters
Basically, the Cursor Key is used for selecting an item, the
selection, and the ESC Key is for canceling the alternation. Taking the procedures in
Guide” as an example, Key operations are explained as follows.
CAUTION:
If "AUTO" is set for "A Range", either "Power + Harmonics"
desirable recording item.. To record the items related to power quality, set it to any other proper current ranges
other than "AUTO". Only the settings of wiring and recording are included in the “Quick start guide”.
The following should be selected and entered before starting a record.
setting screen.
* Nominal voltage/ frequency, THD for power quality event and filter coefficient (ramp) for Flicker
When the setting of "A Range" is set to other than "AUTO", the settings of "+ Clamp" will be automatically
altered to "OFF".
Press the Cursor
is being selected, over the i
left is the Recording start screen. Press the
the blue highlight on the desirable recording method, and press the
ENTER Key to confirm the selection. To quit the start guide, press
the ESC Key.
If the display of t
to the left, then
used. Use the
press the ENTER
previous screen
To alter the numbers such as
over digits with the right and left
with the up and down
In the screen to the left, the tenth place of the day is being selected.
The number can be increased or decreased by 1 with the up/ down
Cursor Key
press the ESC
the changes.
Start measurement with “Quick start guide”
46 -
Key is used for selecting an item, the ENTER Key is for confirming the
Key is for canceling the alternation. Taking the procedures in “Quick Start
as an example, Key operations are explained as follows.
"Power + Harmonics" or "Power only" is selectable at step (1): Select
To record the items related to power quality, set it to any other proper current ranges
other than "AUTO". Only the settings of wiring and recording are included in the “Quick start guide”.
entered before starting a record. Press the key to show the
/ frequency, THD for power quality event and filter coefficient (ramp) for Flicker measurement.
When the setting of "A Range" is set to other than "AUTO", the settings of "+ Clamp" will be automatically
Cursor Key to move the blue highlight , showing the item
is being selected, over the items in blue letters. In the screen to the
left is the Recording start screen. Press the Cursor Key and move
the blue highlight on the desirable recording method, and press the
Key to confirm the selection. To quit the start guide, press
Key.
display of the selectable items is similar to the one shown
then the up, down, right and left Cursor Keys can be
the Cursor Keys to select the proper wiring system and
ENTER Key to confirm the selection. To return to the
previous screen and cancel the changes, press the ESC Key.
To alter the numbers such as Date/ Time , move the blue highlight
over digits with the right and left Cursor Keys and alter the number
with the up and down Cursor Keys.
In the screen to the left, the tenth place of the day is being selected.
The number can be increased or decreased by 1 with the up/ down
Keys. Press the ENTER Key to confirm the selection, or
ESC Key to return to the previous screen and cancel
the changes.