KYORITSU 6315 Instruction Manual - Manual (Page 24)

KEW6315 3.3 Symbols on the LCD
KEW6315 - 22 -
3.3 Symbols on the LCD
*1
W screen: Displays of V and VL can be “customized” when “3P4W” is selected.
*2
W screen: “An” is displayed only when “3P4W” is selected.
*3
W screen: Displays of PA and C can be “customized”.
3.4 Backlight and Contrast Adjustment
Hold down the “ ” LCD Key at least 2 sec to show the sliding bar to adjust the backlight brightness and
display contrast. Use the Cursor Key to slide the cursor on the bar for the adjustment. Press the ENTER
Key and exit from the adjustment mode. Press the ESC or LCD Key again to cancel the adjustment and exit
from the adjustment mode.
V *1 Phase voltage VL *1 Line voltage A Current
P
Active
power
+ consumption
Q
Reactive
power
+ lagging
S
Apparent
power
- regenerating - leading
PF
Power
factor
+ lagging
f Frequency
- leading
DC1
Analog input
voltage at 1ch
DC2
Analog input
voltage at 2ch
An* 2 Neutral current PA*
3
Phase
angle
+ lagging
C*
3
Capacitance calculation
- leading
WP+
Active power energy
(consumption)
WS+
Apparent power energy
(consumption)
WQi+
Reactive power energy
(lagging)
WP-
Active power energy
(regenerating)
WS-
Apparent power energy
(regenerating)
WQc+
Reactive power energy
(leading)
THD
Voltage/ Current
total distortion factor
Pst
(1min)
Voltage flicker (1 min) Pst Short term voltage flicker Plt Long term voltage flicker
Brightness adjustment
Backlight brightness can be changed by 11 levels.
Contrast adjustment
Contrast can be changed by 11 levels.