Metex Shark Multi-Parameter Controllers & Analyzers - Manual (Page 111)

Flow - Utilities Menu - Relay Override 7.3 Page 109
S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Flow - Utilities Menu - Relay Override 7.3
DOWN
DOWN
DOWN
UP DOWN
DOWN
UP
UP
DOWN
DOWN
DOWN
DOWN
If you wish to accept the
Override setting,
Press the key once
to move the cursor to the
RH of the display
With "N" highlighted, pressing the
key will NOT store the Override states of
the relays, but they will revert to the
state they were in before the menu was
entered. Note that, if any of the relays
were in a specific Override state before
the menu was entered (i.e. not in
AUTO), they will revert to that state
again unless the changes are STORED.
TO RELAY OVERRIDE MENU
NOT STORED
DOWN
STORED
If you do not wish to
Override Relay C, then
use the key to
the Alarm Relay
DOWN
FROM RELAY B
OVERRIDE MENU
If you wish to store the state
of the Relay Overrides,
press the key to
highlight the Y character
If you wish to Override Relay
C, Press the key once
which will move the cursor
over to the AUTO/ON/OFF text
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
DOWN Then press the key to store the
Override states of all the relays and
return back to the Override menu
NOTE
Relay C is the Alarm Relay
Then use the key
to move to the Override
setting for Relay C DOWN
UP Use the or key to
change the Override state from
AUTO - controlled by process
settings
ON - relay forced on
OFF- relay forced off
The relay will react
immediately.
DOWN
STORE? Y N
RELAY OVERRIDE
STORE? Y N
RELAY OVERRIDE
RELAY OVERRIDE
RELAY C AUTO >
RELAY OVERRIDE
RELAY OVERRIDE
RELAY C O N >
RELAY C O FF >
RELAY OVERRIDE
RELAY C A UTO >
RELAY C ON >
RELAY C OFF >
RELAY OVERRIDE
RELAY OVERRIDE
RELAY C AUTO >
RELAY OVERRIDE