Metex Shark Multi-Parameter Controllers & Analyzers - Manual (Page 88)

Conductivity - Setup Menu - Temp. Unit 6.9 Page 86
S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Conductivity - Setup Menu - Temp. Unit 6.9
DOWN
DOWN
DOWN
DOWN
DOWN DOWN
DOWN
DOWN
UP DOWN
DOWN
DOWN
UP DOWN
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the TEMP UNIT
Selection Menu. This function is useful
if you wish to view the current selection
without making any changes.
Not stored
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
Then press the key to store the
selection and return to the TEMP UNIT
Selection Menu.
Stored
Or press the key to highlight
the Y character.
TEMP UNIT allows the user to select either
Degrees Centigrade or Fahrenheit units for
display RUN MODE
Press the key once
which will move the cursor
over the unit type, C or F.
Use the or to select C or F
Press the key to accept the
change and move to the store function
Press the key once
which will move the cursor
back to the RH side of the
display.
1000uS 25.0C
UTILITIES
SETUP
CALIBRATION
STORE? Y N STORE? Y N
TEMP UNIT TEMP UNIT
DEGREE C >
DEGREE F >
DEGREE F >
DEGREE C >
TEMP UNIT TEMP UNIT
TEMP UNIT
TEMP UNIT
TEMP UNIT
COND RANGE