Metex Shark Multi-Parameter Controllers & Analyzers - Manual (Page 97)

S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Conductivity - Outputs Menu - Relay A 6.18
Conductivity - Outputs Menu - Relay A 6.18 Page 95
DOWN
DOWN UP DOWN
DOWN
DOWN
DOWN
UP DOWN
DOWN
UP
UP
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN UP
UP DOWN
DOWN
UP
DOWN
DOWN
If you wish to change the setting, press the
key once which will move the cursor to the first
character of the value to be changed
If you wish to change the setting, press the
key once which will move the cursor to the first
character of the value to be changed
If you wish to change the setting, press the
key once which will move the cursor to the first
character of the value to be changed
Relay A can be configured for the following operations
- Response to rising or falling process values
- Adjustable on and off set-points
- Cycle on and off times
- Failsafe operation
TO CYCLE ON
The relay can be set to control either a
RISING or FALLING process.
In a FALLING process, the control relay
will energize when the process falls
below a set value. In this case, the ON
set-point must be set lower than the
OFF set-point.
In a RISING process, the control relay
will energize when the process rises
above a set value. In this case, the ON
set-point must be set higher than the
OFF set-point.
The RELAY ON setting is the process
value at which the relay will energize. It
may be set anywhere in the normal
range of the sensor.
RUN MODE
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
Use the and
keys to change the setting
Press the key once
which will move the cursor
back to the RH side of the
display.
Use the and
keys to change the setting
Press the key to accept the
setting and move to the next setting
Press the key once
which will move the cursor
back to the RH side of the
display.
Use the and
keys to change the setting
Press the key to accept the
setting and move to the next setting
Press the key once
which will move the cursor
back to the RH side of the
display.
RELAY OFF 80 0 >
RELAY OFF 88 0 >
RELAY ON 60 0 >
RELAY ON 68 0 >
DIRECTION FALL >
DIRECTION F ALL >
DIRECTION F ALL >
RELAY OFF 880 >
RELAY ON 680 >
DIRECTION R ISE >
RELAY A
RELAY OFF 800 >
RELAY A
RELAY A
RELAY A
RELAY A
RELAY A
RELAY ON 600 >
RELAY A RELAY A
RELAY A
RELAY A
RELAY A
1000uS 25.0C
CALIBRATION
OUTPUTS
UTILITIES
DIAGNOSTICS
SETUP
DIRECTION FALL >
RELAY A
RELAY A
RELAY A
The RELAY OFF setting is the process
value at which the relay will de-energize.
The setting must be rationalized against
the On setting. For example, in a falling
process, the Off setting must be higher
than the ON setting.
The controller will not allow you to select
the RELAY OFF value on the wrong side
of the RELAY ON value for the selected
direction. If the user tries to set the
RELAY OFF on the wrong side, the
following errors will de displayed:
Error when trying to set OFF point lower
than ON point when set to falling.
Error when trying to set OFF point higher
than ON point when set to rising.
ON SPT < OFF SPT
FALLING PROCESS
ON SPT > OFF SPT
RISING PROCESS