Metex Shark Multi-Parameter Controllers & Analyzers - Manual (Page 117)

Flow - Setup Menu - Totalizer Reset 7.9 Page 115
S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Flow - Setup Menu - Totalizer Reset 7.9
DOWN
DOWN
DOWN
DOWN
DOWN DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
The controller will confirm the action and
return back to the Totalizer Reset menu.
then Press the key to complete
the action.
The controller will ask once more, If you
wish to reset the totalizer, press the
key to highlight the Y character
If you wish to reset the totalizer, press the
key to highlight the Y character
Totalizer Reset is used to reset the Flow totalizer to zero.
Note that this once complete, this action cannot be reversed, the
accumulated total will be erased permanently.
When the totalizer "roles over", an auxillary LED will light up up
the front panel.
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
If you do not wish to reset the totalizer,
Press the key which will return
back to the Totalizer Reset menu
DOWN
If you do not wish to reset the totalizer,
Press the key which will return
back to the Totalizer Reset menu
RUN MODE
DOWN
DOWN
then Press the key to confirm
the action. DOWN
TO 0
TOTALIZER RESET
CONFIRM Y N
RESET? Y N
TOTALIZER RESET
TOTALIZER RESET
CONFIRM Y N
TOTALIZER RESET
DISPLAY DAMPING
UNITS OF TIME
UNITS OF VOLUME
AUTO RETURN
TOTAL 0
UTILITIES
SETUP
CALIBRATION
TOTALIZER RESET
TOTALIZER RESET
RESET? Y N