Metex Shark Multi-Parameter Controllers & Analyzers - Manual (Page 32)

pH - Setup Menu - Auto Return 4.11 Page 30
S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
pH - Setup Menu - Auto Return 4.11
DOWN
DOWN
DOWN
DOWN
DOWN
Not stored
DOWN
DOWN
Stored
DOWN
DOWN
DOWN
DOWN
UP DOWN
DOWN UP
DOWN
DOWN
DOWN
DOWN
DOWN
UP DOWN
DOWN UP
CAUTION:
If AUTO RETURN RELAYS is ON, regardless of
the user settings of the states of the relays, Relays
will default to AUTO 10 minutes after the Shark
returns to Run Mode.
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the AUTO RETURN
Selection Menu. This function is useful if
you wish to view the current selection
without making any changes.
Then press the key to
store the selection and return
to the Auto Return Selection
Menu.
Press the key to
accept the change and move
to the STORE function
Or press the key to highlight
the Y character.
Press the key to accept the change
and move to the RELAYS auto return
function. RELAYS ON will cause the relays to
return to the AUTO mode if the controller
returns to Online after 10 minutes of inactivity.
This ensures the controller will be put back in
control of the process if accidentally left
offline.
Use the or keys
to select either ON or OFF.
Press the key once
which will move the cursor to
the ON or OFF text
Press the key once
which will move the cursor
back to the RH side of the
display.
RUN MODE
To change the MENU
RETURN setting,
Press the key once
which will move the cursor to
the ON or OFF text
Use the or
keys to select either ON or
OFF.
Press the key
once which will move
the cursor back to the
RH side of the display.
MENU ON will cause the controller to exit the menu and
revert back to the online run mode after 10 minutes with no
buttons pressed. This feature ensures that if a user forgets
to return back to run mode, the controller will not be left in
an offline state. If for some reason, the user would like to
remain in the menu mode for extended periods of time, the
AUTO RETURN function can be set to "OFF".
AUTO RETURN is used to select what conditions will
cause the controller to time-out of the operations
menu, or reset the relay override function.
7.15pH 25.0C
SETUP
UTILITIES
CALIBRATION
STORE? Y N STORE? Y N
AUTO RETURN
RELAYS OFF >
AUTO RETURN
AUTO RETURN
RELAYS ON >
RELAYS O N >
RELAYS O FF >
AUTO RETURN
AUTO RETURN
AUTO RETURN
AUTO RETURN AUTO RETURN
MENU ON >
TEMP SENSOR
TEMP UNIT
PROBE SELECTION
AUTO RETURN
MENU OFF >
AUTO RETURN
AUTO RETURN
MENU O FF >
MENU O N >