Metex Shark Multi-Parameter Controllers & Analyzers - Manual (Page 89)

S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Conductivity - Setup Menu - Temp. Sensor 6.10
Conductivity - Setup Menu - Temp. Sensor 6.10 Page 87
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
UP
UP
DOWN
DOWN
UP DOWN
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the TEMP SENSOR
Selection Menu. This function is useful
if you wish to view the current
selection without making any changes.
RUN MODE
Then press the key to store the
selection and return to the TEMP
SENSOR Selection Menu.
Press the key to accept the
change and move to the store function
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
Not stored Stored
Or press the key to highlight
the Y character.
Press the key once
which will move the cursor
over to the sensor type.
Once the correct Sensor has
been selected press the
key once which will move the
cursor back to the RH side of
the display.
Use the or to select
the sensor type
TEMP SENSOR allows the user to select the
type of temperature sensor used the in the
probe.
The factory default for Conductivity is a 3000
Ω
NTC thermistor. The user can also select a
300
Ω NTC thermistor or a Pt. 1000 RTD.
TEMP SENSOR
1000uS 25.0C
CALIBRATION
UTILITIES
SETUP COND RANGE
TEMP UNIT
STORE? Y N STORE? Y N
3 00 NTC >
TEMP SENSOR
TEMP SENSOR
TEMP SENSOR
3000 NTC >
3 000 NTC >
1 000 RTD >
3000 NTC >
Ω
TEMP SENSOR
TEMP SENSOR
Ω
Ω
TEMP SENSOR
TEMP SENSOR
Ω
Ω