Metex Shark Multi-Parameter Controllers & Analyzers - Manual (Page 52)

S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
ORP - Calibration Menu - Temp. Calibration 5.2
ORP - Calibration Menu - Temp. Calibration 5.2 Page 50
DOWN
DOWN DOWN
DOWN UP
DOWN
DOWN UP
DOWN
DOWN
DOWN
DOWN
If the Temperature Display Override is set to ON (see
section 5.11), the Shark cannot calibrate the temperature
sensor. This display will appear to alert the user to the
condition.
If the calibration did not appear to
be correct, press the key
which will return back to the Temp
Calibration menu.
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
This will store the calibration data
and return back to the Temp
Calibration setup so the user can
select another function.
Use the and to adjust
the reading until it agrees with the
known temperature of the probe
Press the key to accept the
reading and move to the store function
"T FACTOR SHIFTED" will be
displayed for 5 seconds to indicate that
the temperature sensor has been
calibrated.
The Shark will then move to the store
function.
The controller displays the current probe
temperature.
If this incorrect, the controller can be
adjusted to compensate.
Press the key once
which will move the cursor
back to the RH side of
temperature display.
Press the key once which will move
the cursor over the least sign. digit of the
temperature display.
RUN MODE
STORE? Y N
TEMP CALIBRATION
STORE? Y N
TEMP CALIBRATION
TEMP CALIBRATION
25.0C >
T FACTOR SHIFTED
25. 0 C >
TEMP CALIBRATION
TEMP CALIBRATION
TEMP CALIBRATION
TEMP CALIBRATION
22. 4 C >
22.4C >
TEMP CALIBRATION
TEMP O/R ON >
500mV 25.0C
CALIBRATION MANUAL CAL PH
DOWN