Brother MFC-9800 - Manual (Page 75)

A U T O D I A L N U M B E R S A N D D I A L I N G O P T I O N S 7 - 4
4
When the LCD shows the name you want to call, press Fax Start to begin
dialing.
If you use the scanner glass, press Fax Start again.
Speed Dialing
1
Place the original face up in the ADF, or face down on the scanner glass.
2 Press Search/Speed Dial, #, and then press the two-digit Speed Dial number.
3
Press Fax Start.
One Touch Dialing
1 Place the original face up in the ADF, or face down on the scanner glass.
2
Press the One Touch key of the location you want to call.
3
Press Fax Start.
Access Codes and Credit Card Numbers
Sometimes you may want to choose from among several long distance carriers
when you make a call. Rates may vary depending upon the time and destination.
To take advantage of low rates, you can store the access codes or long-distance
carriers as One Touch and Speed Dial numbers. You can store these long dialing
sequences by dividing them and setting them up separately in any combination.
You can even include manual dialing using the dial pad. The combined number
will be dialed in the order you entered it, as soon as you press Fax Start. (See
Storing One Touch Dial Numbers , page 7-1.)
You store “555” on One Touch key 03 and “7000” on One Touch key 02. If
you press One Touch 03, 02 and Fax Start you will dial “555-7000”. To
temporarily change a number, you can substitute part of the number with manual
dialing using the dial pad. For example, to change the number to 555-7001 you
can press One Touch 03, and then press 7, 0, 0, 1 using the dial pad.
If you try to use a One Touch or Speed Dial location with no number stored in
it, you hear a warning sound, and LCD shows
NOT REGISTERED . The LCD
returns to normal after 2 seconds.
Note
If you must wait for another dial tone at any point in the dialing sequence, store
a pause at that point in the number by pressing Redial/Pause. Each key press
adds a 3.5 second delay.