Brother MFC-9800 - Manual (Page 98)

12 - 1 F O R D O S U S E R S
12
12
For DOS Users
How to Use the Brother MFC with Your DOS
Application Software
Before working with your application software that runs on DOS, check that the
Brother MFC’s name appears in the printer selection of your application
software. If the MFC is not listed, you must install the printer driver that
corresponds to HP LaserJet’s emulations.
The following table shows combinations of printer drivers and emulation mode.
To get the most out of this MFC, you should install an HP printer driver in your
application software.
■
The best or recommended printer driver is indicated in bold.
■
Be sure to choose the proper printer driver in your application software.
■
Be sure the printing resolution is set to 600 dpi in your DOS application
software.
What Does the Remote Printer Console Do?
The Remote Printer Console (RPC) is a utility program that can run in the DOS
environment and comprises the following program:
Remote Printer Console Main Program
This program allows you to change various printer settings such as emulation,
print quality, fonts and page setup from your computer screen. Since most DOS
applications have a Printer Settings menu that overrides the settings made by the
RPC, you may not have to use this utility program. This utility program is useful
for application software that does not control the printer’s settings and features.
Printer driver supported in
your application software Emulation mode to be selected with the remote
printer console program
HP LaserJet ™ HP LaserJet emulation mode