Acura 2009 Accord Sedan - Manual (Page 555)

Install a new oil filter according to
the instructions that come with it.
Make sure to clean off any dirt
and dust on the connecting
surface of a new oil filter.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
Refill the engine with the
recommended oil.
Engine oil change capacity
(including filter):
Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Make sure the oil filter gasket is
not stuck to the engine block. If it
is, remove it before installing a
new oil filter.
Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood, and remove the
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
3.
5.
6.
4.
1.
2.
CONTINUED
Changing the Oil and Filter
Ma
int
e
na
nce
549
OIL FILTER
DRAIN BOLT WASHER
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.5 US qt (4.3 )