Acura 2009 Accord Sedan - Manual (Page 603)

If the fluid level is low, take your
vehicle to a dealer, and have the
brake system inspected for leaks or
worn brake pads.
However, if the brake pedal does not
feel normal, you should take
immediate action. A problem in one
part of the system’s dual circuit
design will still give you braking at
two wheels. You will feel the brake
pedal go down much farther before
the vehicle begins to slow down, and
you will have to press harder on the
pedal.
The brake system indicator normally
comes on when you turn the ignition
switch to the ON (II) position, and as
a reminder to check the parking
brake. It will stay on if you do not
fully release the parking brake.
Models equipped with the keyless
access system have an engine start/
stop button instead of an ignition
switch. ON Mode is the equivalent of
ON (II). See page
for ignition
switch and power mode comparison.
If the brake system indicator comes
on while driving, the brake fluid level
is probably low. Press lightly on the
brake pedal to see if it feels normal.
If it does, check the brake fluid level
the next time you stop at a service
station (see page
).
You will also see a ‘‘LOW BRAKE
FLUID’’ message on the multi-
information display.
You will also see a ‘‘CHECK BRAKE
SYSTEM’’ message on the multi-
information display when this
indicator comes on.
To check if they are set, turn the
ignition switch to the ON (II)
position (set ON mode on models
with keyless access system), without
starting the engine. The malfunction
indicator lamp will come on for 20
seconds. If it then goes off, the
readiness codes are set. If it blinks
five times, the readiness codes are
not set. If possible, do not take your
vehicle for an emissions test until the
readiness codes are set. Refer to
for more
information (see page ).
555
626
180
CONTINUED
Malfunction Indicator Lamp, Brake System Indicator
Brake System
Indicator
Emissions Testing
T
a
k
ing
Ca
re
of
th
e
U
ne
x
p
e
c
te
d
597
Canada U.S.