Acura 2009 Accord Sedan - Manual (Page 570)

If your seat belts get dirty, use a soft
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry before
you use the vehicle.
Push a new bulb straight into the
socket until it bottoms, and
reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Test the new bulb to make sure it
works.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Put the holding clip into the hole
on the side of the trunk lining.
Reinstall the screw.
Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.
Determine which of the three
bulbs is burned out: back-up light,
turn signal, or side marker.
6.
7.
8.
9.
5.
4.
Lights, Cleaning the Seat Belts
Cleaning the Seat Belts
564
OPENING
BULB SOCKET