HP EML E-series Tape Libraries - Manual (Page 17)

The Interface Manager card communicates with the management station over the LAN. The
management station is a Microsoft Windows-based PC (server) that hosts the Command View TL
software. Ideally, the management station should have a static IP address, and be dedicated for
use with the Interface Manager card and Command View TL software.
IP connections on the EML can be IPv4 or IPv6 format. The library can be configured to use one
or both formats, but can not operate if neither protocol is enabled. View the IP connections on the
Identity Screen (from the Home screen select Status, then Identity Screen).
Figure 11 Viewing IP connections from the Identity Screen
Enable or disable the protocols from the Change Network Settings screen, then view and save the
settings from that same screen.
To view and change the settings for either IPv4 or IPv6:
1.
From the Home screen, select Configuration.
2. From the Library Configuration menu select Change Network Settings.
Figure 12 Viewing the Change Network Settings screen
3. To enable or disable IPv4 or IPv6, touch the appropriate Enable or Disable button.
4. To view or change the settings, touch the appropriate Settings button.
NOTE: Some settings are read-only.
Controller cards 17