HP EML E-series Tape Libraries - Manual (Page 68)

7. Move the CompactFlash card.
a.
The Interface Manager card contains a CompactFlash card which stores the library
configuration. To retain the library configuration, move the CompactFlash card to the
replacement Interface Management card.
b. Grasp the edges of the CompactFlash card and slide it out of the slot on the original
Interface Manager card. If needed, push a pen into the corner notches of the slot to unseat
the CompactFlash card.
c. Remove the replacement Interface Manager card from its protective sleeve and place it
on your work surface.
d. With the connector going in first, align the sides of the CompactFlash card with the slot
on the replacement Interface Manager card. Gently slide the CompactFlash card into the
slot until it is securely seated.
NOTE:
If the CompactFlash card does not slide in easily, it is upside down. Pull the card back out,
flip it over, and reinsert it into the slot.
Replacing the Interface Manager card 480240-001
1. Reinstall the Interface Manager card.
a.
Align the Interface Manager with the guides in the base module card cage and slide the
Interface Manager into the library.
b. Push the ejection handles to the inside to fully seat the card. Tighten the captive screws.
2. Plug the cables into the new Interface Manager card exactly as they were plugged into the
original card.
68 Removing and replacing parts