HP EML E-series Tape Libraries User Manual
Page 66
10. Compare the memory modules.
a.
Locate the memory module on the old and replacement Interface Manager cards. Compare
the memory modules on the two cards.
•
If the memory module on the old Interface Manager card has more memory, follow
the instructions in
to put the larger memory module on the new Interface
Manager card.
•
If the memory modules on the two Interface Manager cards have the same amount
of memory or the new Interface Manager card has more memory, skip
and continue with
“Replacing the Interface Manager card 342213-001 or
Figure 51 Comparing memory modules
b.
Remove the memory module from both Interface Manager cards. To remove the memory
module from the Interface Manager card, pull the latches away from the memory module
on both sides. When both latches are unfastened, the memory module pops up.
Grasp the edge of the memory module and pull it out of the socket.
Insert the memory module with the most memory into the memory module socket on the
replacement Interface Manager card. Push down on the module to fasten the latches.
Insert the other memory module into the memory module socket on the old Interface
Manager card. Push down on the module to fasten the latches.
Replacing the Interface Manager card 342213-001 or 393531-001
1.
Position the Interface Manager card as shown in
. Align the Interface Manager card
with the guides in the bottom slot in the card cage in the base module and slide the Interface
Manager card into the library.
2.
Push the ejector handles to the inside to fully engage the Interface Manager card into the
backplane.
3.
Tighten the captive screws in both ejector handles. Use a #1 Phillips screwdriver.
4.
Plug the cables into the Interface Manager card exactly as they were plugged into the original
Interface Manager card (see the labels on the cables or the note that you wrote).
5.
Turn on the power to the library.
NOTE:
Because all of the configuration settings for the Interface Manager card are stored
on the CompactFlash memory card that you moved, your new Interface Manager card retains
the configuration of the original card. To examine or change these settings, see the HP Interface
Manager and Command View TL User Guide.
6.
Make sure that the status LEDs indicate a normal state (see
).
66
Removing and replacing parts