HP EML E-series Tape Libraries - Manual (Page 65)

6. Loosen the captive screws in the ejector handles at both ends of the Interface Manager card.
Use a #1 Phillips screwdriver.
CAUTION: Be aware that the metal tabs on the gasket on the filler panel can be caught and
bent by the pins on the Interface Manager card. If bent, these tabs can cause a short circuit.
Avoid removing or installing the Interface Manager card at an extreme angle and watch that
the metal tabs on the gasket do not get caught or bent.
7. Push the ejector handles to the outside, and then pull the ejector handles to remove the Interface
Manager card from the library.
8. Pull the ejector handles to remove the Interface Manager card from the library.
Figure 49 Removing the Interface Manager card
9. Move the CompactFlash memory card from the original Interface Manager card to the new
Interface Manager card. The CompactFlash memory card stores the firmware and configuration
information for the Interface Manager card.
a.
Put the Interface Manager card battery-side up on your work surface.
b. Grasp the edges of the CompactFlash memory card and slide it out of the flash memory
slot. If needed, push a pen into the corner notches of the flash memory slot to disengage
the CompactFlash memory card.
Figure 50 Removing the CompactFlash memory card from the Interface Manager card
2. Flash memory slot 1. Interface Manager card
3. CompactFlash memory card
c. Put the new Interface Manager card battery-side up on your work surface.
d. With the connector going in first, align the sides of the CompactFlash memory card with
the flash memory slot on the new Interface Manager card. Gently slide the CompactFlash
memory card into the slot until it is fully engaged. If the CompactFlash memory card does
not slide in easily, the card is upside down.
Interface Manager card 65