Load port magazine, Removing a load port magazine, Replacing a load port magazine – HP EML E-series Tape Libraries User Manual
Page 75
Load port magazine
375813-001
Part number
Inside the load port door on the right side of the base module, tape
drive expansion module, and capacity expansion module
Location
One column, five slots
Characteristics
Holding tape cartridges for placement into library
Function
Illustration
Removing a load port magazine
1.
On the OCP, select the Operations
→Unlock Load Ports command. All load port doors open.
2.
Fully open the load port door.
3.
Grab the handle and pull the magazine out of the load port along its track to remove it from
the library.
CAUTION:
Guard plates prevent access to the inside of the library when a load port
magazine is removed. These doors will move back out of the way when a magazine is
reinserted. You should not attempt to otherwise move these guards, nor gain access to the
library through the load ports.
Replacing a load port magazine
1.
Align the magazine with the top and bottom track on the load port door, and slide the
magazine through the spring door and fully into the load port.
2.
Close the load port door.
Load port magazine
75