HP EML E-series Tape Libraries - Manual (Page 39)

Table 4 Status screen functions (continued)
Description Function
Enables you to filter informational, warning, and critical events. The five
most recent events of any category are listed with the oldest listed first Event Log Type Selection
and the most recent listed last. Filtering events does not remove them from
the log.
Identifies the status of each tape drive and slot location. View Library Inventory
Configuration screen
The Configuration screen provides administrator access to screens that enable you to change the
library configuration and enables any user to adjust the contrast of the OCP screen.
Figure 33 OCP Configuration screen
Table 5 Configuration screen functions
Description Function
enables the following items to be configured: Library Configuration
• Change Password—The library ships with a null password. Passwords
must be set to exactly eight characters, consisting of the numbers 0
through 9 and the period character. The password can be required to
unlock load ports. If you forget your password, contact HP support.
HP support can generate a temporary password that will enable you
to access the library.
Change Password is also used to set whether the admin password is
required to unlock the library load ports from the OCP. After entering
the existing or a new password (Configuration+Library
Configuration
→Change Password), the Load Port Access Password
Option screen appears and indicates whether the password is required
or not. To toggle the setting to require the password, press the box
containing the text OCP admin password NOT required for load port
access. If the box already contains the text OCP admin password
required for load port access, the password is already required. (Press
the text box again, if appropriate, to disable password protection of
the load ports.) Press the Save button on the OCP.
• Configure Load Ports—Shows the number of installed load ports and
enables you to toggle between using each as a load port or for tape
slots. Configure it as a Load Port to move tapes in and out of the library.
Configure as Slots to increase the number of storage slots in the library.
Changing a load port configuration causes a library reboot.
• Change Network Settings—Configures the network settings for the
Interface Manager card, which can be automatically set with DHCP
(IPv4 DHCP is default), IPv4 static address, or variety of IPv6 addresses.
Using the OCP 39