HP EML E-series Tape Libraries - Manual (Page 40)

Table 5 Configuration screen functions (continued)
Description Function
Both IPv4 and IPv6 can be enabled, but both cannot be disabled at
the same time.
•
Configure Barcode Reporting Formats—Defines how barcodes appear
on the OCP and sent to the host. Barcode reporting can be configured
as 6 to 8 characters and left or right aligned. If 6 characters with left
alignment is chosen, any characters after the six are truncated. With
6 characters and right alignment, only the last six characters are shown
with the beginning characters truncated.
• Configure Reserve Slots Up to nine slots can be reserved for special
purposes, such as cleaning tapes. The default is none. Select the number
you want to reserve and select Save.
NOTE: Reserve slots are not available on the EML 71e.
• Configure Inventory Mode enables you to require barcodes on tape
cartridges, or to make them optional. Requiring barcodes significantly
shortens inventory time.
Use the up and down arrows to adjust the screen contrast. The screen
refreshes each time an arrow is pressed. Select the OK button when
finished. Adjust Screen Contrast
Operations screen
The Operations screen provides access to screens that enable you to unlock load ports, unlock the
library door, reboot the library, move tapes, clean tape drives, and run administrative tests.
Figure 34 OCP Operations screen
Table 6 Operations screen functions
Description Function
Instructs the robot to unlock all load port doors. In library firmware version
1407 or later, this option can be protected using the admin password. Unlock Load Ports
(Password protection is enabled or disabled from the Configuration
screen.) When all load port doors are closed, each load port is scanned
and inventoried.
Parks the robot, which enables you to open the center door of the library.
The library is reinventoried after the center door is closed. Unlock Door
Does a library reboot. Does an inventory of all tape slots and rediscovers
all hardware controllers and tape drives. Reboot Library
40 Using the library